Make your own free website on Tripod.com


 

 

QT-16 Safety and Operation Instruction

Page 19

MAINTENANCE (continued)

FUEL FILTER

There is a fuel filter in the line from the fuel tank. See figure 23 for location. This filter is a throw away type. When it shows excessive dirt in the inside it should be replaced. When replacing the filter turn off the fuel valve. This valve is located on the underside of the fuel tank. See figure 23 for location. Open valve again after filter has been replaced.

SPARK PLUGS
Every 100 hours remove plugs, check condition and reset to .025 inch (.63mm) gap or replace plugs if needed. Good operation conditions are indicated if plugs have a light coating of gray or tan deposit. A dead white, blistered coating could indicate an "over-rich" fuel mixture caused by clogged air cleaner or improper carburetor adjustment. Do not service plugs in poor condition - best results are obtained with new plugs.

NOTE
Cleaning of spark plugs in cleaning . machines that use abrasive grit is not recommended. Spark plugs should be cleaned by scraping or wire brushing and washing with a commercial solvent.

 

(Champion RH-8)

Fig. 24

COMPLIANCE WITH RADIO INTERFERENCE REGULATIONS CERTIFIED REPLACE SPARK PLUG WITH RESISTOR SPARK PLUG ONLY!

CERTIFIE CONFORME AU REGLEMENT SUR LE BROUILLAGE RADIO-ELECTRIGUE. REMPLACER LA BOUGIE PAR UNE BOUGIE A RESISTANCE SEULEMENT!




 

Previous Next Page 20 Contents Home